PETOL™ Hydraulic Friction Tongs with Chain

Friction jaw is machined to fit a specific O.D. and helps minimize surface marring of pump sections during makeup or breakout
Handle is designed to connect to clevis on hydraulic cylinder
Tongs attach or remove easily from hydraulic cylinder by a quick release pin provided with the Hydraulic Pump Bench

PART NO.	O.D.	GRIPPING WIDTH	WEIGHT	MAXIMUM WORKING LOAD*
PETOL™ Hydraulic Friction Tongs with Chain
Click any Part No. to send an inquiry.
FA3:3.000U	3.000"	4.31"	31 lbs.	8,500 ft-lbs.
FA3:3.125U	3.125"	4.31"	31 lbs.	8,500 ft.-lbs.
FA3:3.250U	3.250"	4.31"	31 lbs.	8,500 ft.-lbs.
FA3:3.500U	3.500"	4.31"	31 lbs.	8,500 ft.-lbs.
FA3:3.625U	3.625"	4.31"	31 lbs.	8,500 ft.-lbs.
FA3:3.750U	3.750"	4.31"	31 lbs.	8,500 ft.-lbs.
FA3:4.000U	4.000"	4.31"	31 lbs.	8,500 ft.-lbs.
FA4:4.000U	4.000"	4.31"	38 lbs.	10,200 ft.-lbs.
FA4:4.250U	4.250"	4.31"	38 lbs.	10,200 ft.-lbs.
FA4:4.500U	4.500"	4.31"	38 lbs.	10,200 ft.-lbs.
FA4:4.750U	4.750"	4.31"	38 lbs.	10,200 ft.-lbs.
FA4:5.000U	5.000"	4.31"	38 lbs.	10,200 ft.-lbs.
FA4:5.250U	5.250"	4.31"	38 lbs.	10,200 ft.-lbs.
FA4:5.375U	5.375"	4.31"	38 lbs.	10,200 ft.-lbs.
Special O.D. sizes available upon request. Special sizes are non-returnable. *Maximum Working Load of the Friction Breakout Unit hydraulic system is 5,000 ft.-lbs. If used aside from Breakout Unit, torques vary according to the tong being used.

Files are PDF under 1MB unless otherwise noted.

Safe Practices & Procedures Manual (1.2MB)

WARNING!
Do Not Exceed Maximum Working Load!
Overloading may result in SERIOUS INJURY or DEATH.
Always use a load cell or other calibrated indicating device to monitor the line pull on the tong to avoid overload.
Read Safe Practices & Procedures Manual prior to operation. Do not operate without a manual. Follow OSHA, NSC, etc. standards, safe practices, and procedures.

Metric Conversion Calculator

Enter a value into any field and click “Convert”

Inches: = Millimeters:

Pounds: = Kilograms:

Metric Torque Conversion

This same configuration can be used for all tongs.
Enter a value into either field and click “Convert”

TORQUE (ft.-lbs.) = FORCE (lbs.) x LENGTH (in.) /12

Ft. lbs.: N*m:

Click Part No. to view table.