PETOL® HYDRA-TORK® Units

PETOL® HYDRA-TORK® UNITS are designed for fast and easy operation when making up or breaking out pipe and tool joints. The units are equipped with PETOL Pulldown Visetongs and Tongvises to provide the greatest strength while minimizing marks on pipe surfaces. The heat-treated PETOL Special Chains on these tools are easily adjusted without disassembling the chain sections. The remote control console for the hydraulic system provides pressure gauges with exact read-out in ft.-lbs. of torque, as well as PSI. For added safety, a controlled pressure relief valve allows the operator to adjust the working pressure for each job. When the set pressure is accomplished the system stops torquing.

PETOL HYDRA-TORK Units are designed in a manner that enable them to be adapted to meet the many different requirements of each downhole tool manufacturer and service shop. Please call our factory for any custom design requirements needed.

RELATED PRODUCTS

PART NO.	O.D.	WEIGHT	MAXIMUM WORKING LOAD
PETOL® HYDRA-TORK® Units
Click any Part No. to send an inquiry.
U115H	2" - 8"	1,255 lbs.	14,000 ft.-lbs.
U116H	4" - 14"	2,860 lbs.	50,000 ft.-lbs.
U118	4" - 24"	3,380 lbs.	90,000 ft.-lbs.
U120	6" - 24"	5,500 lbs.	200,000 ft.-lbs.

Files are PDF under 1MB unless otherwise noted.

Safe Practices & Procedures Manual (1.2MB)

OPERATING MANUALS

U115H / U115H-S (3.0MB)

U116H / U116H-S (3.6MB)

U118 / U118-S (2.9MB)

U120 / U120-S (1.7MB)

WARNING!
Do Not Exceed Maximum Working Load!
Overloading may result in SERIOUS INJURY or DEATH!
Always use a load cell or other calibrated indicating device to monitor the line pull on the tong to avoid overload.
Read Safe Practices & Procedures Manual prior to operation. Do not operate without a manual.
Follow OSHA, NSC, etc. standards, safe practices, and procedures.

PETOL® HYDRA-TORK® UNITS

Data Logging System

Optional add-on feature.

Metric Conversion Calculator

Enter a value into any field and click “Convert”

Inches: = Millimeters:

Pounds: = Kilograms:

Metric Torque Conversion

This same configuration can be used for all tongs.
Enter a value into either field and click “Convert”

TORQUE (ft.-lbs.) = FORCE (lbs.) x LENGTH (in.) /12

Ft. lbs.: N*m:

Click Part No. to view table.